Specifications

8
8 8
8 CL408
CL408CL408
CL408
e
ee
e
/412
/412/412
/412
e
ee
e
2. Introduction
2. Introduction2. Introduction
2. Introduction Operation Manual
Operation ManualOperation Manual
Operation Manual
RIBBON SENSOR:
RIBBON SENSOR: RIBBON SENSOR:
RIBBON SENSOR:
Thi
s sensor
i
s a mot
i
on
d
etector t
h
at
signals the printer when the ribbon supply is turning. This
sensor is used for both the ribbon end and ribbon near end
(approximately 45 feet) sensing.
LABEL SENSOR:
LABEL SENSOR: LABEL SENSOR:
LABEL SENSOR: Both the “I” - mark (reflective) and
Gap(transmissive) sensors on the CL408/412 can be adjust
e
over a limited range. They are both located in the label
sensor unit. The assembly can be adjusted by loosening th
e
green sensor adjust knob located underneath the label
transport assembly and sliding the label sensor unit to the
desired position. The gap sensor can be adjusted from a
minimu m of 0.67 in (17mm) to a maximum of 2.5 in. (64 mm
)
and the “I” - mark from a minimum of 0.25 in. (6 mm) to a
maximum of 2.1 in. (53 mm) from the fixed position, “inside
label guide”. -
SENSOR
SENSORSENSOR
SENSOR
ADJUST
ADJUSTADJUST
ADJUST
KNOB
KNOBKNOB
KNOB
I
II
I -
--
- mark
markmark
mark
G
GG
G ap
apap
ap
Sensor unit
Sensor unitSensor unit
Sensor unit