Specifications

Operation Manual
Operation ManualOperation Manual
Operation Manual 3. Configuration
3. Configuration3. Configuration
3. Configuration
CL408
CL408CL408
CL408e
ee
e/412
/412/412
/412e
ee
e 21
21 21
21
3.1.2
3.1.23.1.2
3.1.2 External Connector PIN Assignments
External Connector PIN AssignmentsExternal Connector PIN Assignments
External Connector PIN Assignments
PIN
PINPIN
PIN DIRECTION
DIRECTION DIRECTION
DIRECTION SIGNAL DESCRIPTION
SIGNAL DESCRIPTIONSIGNAL DESCRIPTION
SIGNAL DESCRIPTION
1 To Host Label Out - This pin goes low (0V) when a label out
error exists.
2 Reference Signal Ground
3 To Host Ribbon Out - This pin goes low when the ribbon is out.
4 To Host Error - This pin goes low when the printer detects an
error condition such as head open or receiving buffer
full.
5 To Printer Print Start - The printer will print one label when this
pin is pulled to ground. This signal must be enabled
by placing switch DSW3-5 on the Control Panel in the
OFF position.
6 To Host End Print - It is used to drive an applicator or other
external device requiring synchronization with the print
cycle. You may choose between four types of output
signals using control panel DSW3-6 and DSW3-7 sel-
ections.
7 To Printer Print Repeat - The printer repeatedly prints the current
label in the print buffer immediately after receiving this
signal.
DSW3-8 must be ON.
8 To Printer Vcc - +5V
9To HostOn-Line
10 To Host Ribbon Near End
11 To Printer TBD
12 To Host +24V - Used to power accessory items.
13 To Host Vcc - +5V
14 Reference Frame Ground