Printer User Manual

Page 6-9
Section 6. Replacement Procedures
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. B
6.4 Replacing the Power Supply
The Power Supply is a non-repairable component with no service parts and
is replaced as a complete assembly.
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the access door and remove (2) screws holding the side cover to the
inside frame. Figs. 6-1
3. Remove (2) screws holding the side cover to the outside frame. Remove the
cover to expose the electronics.
4. Remove (2) screws holding the power supply to the back of the cabinet and
(1) screw from inside the cabinet. Detach the connections. Figs. 6-9
5. Remove and replace the defective power supply.
6. Replace the cover and reconnect the power cable.
7. Check the DC power voltages. Refer to Section 4.3.