Printer User Manual

Page 2-33
Section 2. Configuration
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. B
STEP PROCEDURE
4. Use the FEED key to select the desired setting. If you only want to read
the counter value, select NO. If you want to read the counter and reset it
to 0.0, place the underline cursor under YES. Once the desired setting is
selected, press the FEED key to return to the Counter Mode display.
To exit the Counters Mode power the printer off, then back on.
counters mode
Test Print Mode
The Test Print Mode offers four different printer status labels for troubleshooting. If
DSW3-5 is ON, the Test Print cycle must be initiated with a Print Start signal.
This option allows you to print a test label. It is recommended that you print a test label
after you have changed any of the settings in the Advanced Mode. The test label allows
you to verify that you indeed did make the desired changes.
To enter the User Test Print Mode:
Test Print Mode
Configuration
STEP PROCEDURE
1. Power on the printer while pressing the FEED key. Release the FEED
key and the printer will display the Test Print Mode message on the
LCD panel.
2. Use the LINE key to step the underline cusror to the type of test label
you wish to print. The choices are:
Configuration
Bar Code
Head Pattern
Memory
Factory
test print mode
configuration
See last pages in this section for
test label sample print-outs
3. Once you have selected the type of test label to be printed, use the FEED
key to accept the selection and advance to the Test Print Size display. This
display allows you to select the label width.
LCD Panel — Counters Mode