All in One Printer User Manual

Table

4. Printed Overstrike Error Messa

Error Messa

lanation

ag R/W Err

Check media

Ta g C o m m

Err

Check cable

The printer software attempted to write to or read from the

RFID tag, but the RFID encoder indicated that the tag could

not be written to, or read from.

The printer software temporarily lost communication with the

RFID encoder, or communication between the printer

software and the RFID encoder was not synchronized and

had

o be fo

ced.

NOTE:

The x in the error messages represents a number code that identifies the area

in the printer software or RFID encoder where the failure occurred.

Custom Setting

This menu item contains submenus that allow the RFID encoder to work with tag types that are not

listed in the Tag Type menu item.

NOTE: SATO cannot guarantee the performance of tag types not certified by SATO.

Custom Setting Submenus

Custom Tag

This menu item enables or disables the Custom Setting submenus. The default is Disable.

When Custom Tag is set to Disable, the settings in the Custom Setting submenus are ignored by

the RFID encoder.

When it is set to Enable, the RFID encoder uses the settings in the Custom Setting submenus,

which must be set to match the characteristics of the custom tag.

When it is set to Duplicate, the settings of the selected Tag Type menu item are copied into the

Custom Setting submenus, but are ignored by the RFID encoder.

RFID

con

gura

on op

ons