Service manual

PN 9001098
Rev. A
2-21
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
STEP PROCEDURE
4. Once the copy process is completed, press the ENTER key to step the display.
5. If an error is encountered in the copy process, one of the following messages
will be displayed on the second line.
R/W Indicates a Read/Write error occured.
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
card->memorycopy
completed
cardcopy/format
xxxxxxx error
LCD Panel — Card Mode
Card -> Card Copy
All <XMB> Y/N
This selection allows you to copy the entire contents of the optional Expanded Memory to the
PCMCIA Memory card installed in the Memory Card slot on the rear of the printer.
STEP PROCEDURE
1. Use the keys to step the cursor to either YES copy or NO.
If Yes is selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the Card to Memory Copy All mode.
2. Confirm your selection by stepping the cursor to the Yes selection. If you
selected No, the display will return to the previous selection.
3. Press the ENTER key to accept the selection. If Yes was selected, the copy
process will start.
copy start
yes No
memory->cardcopy
copying
card -> cardcopy
all <Xmb> y/n