Service manual

SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-22
Section 2. Configuration
STEP PROCEDURE
4. Once the copy process is completed, press the ENTER key to step the display.
5. If an error is encountered in the copy process, one of the following messages will
be displayed on the second line.
R/W Indicates a Read/Write error occured.
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
memory->Cardcopy
completed
cardcopy/format
xxxxxxx error
LCD Panel — Card Mode
This selection allows you to copy printer firmware from the PCMCIA Memory Card to the
printer.
STEP PROCEDURE
1. Use the keys to step the cursor to either YES copy or NO.
If Yes is selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the mode display.
2. Confirm your selection by stepping the cursor to the Yes selection. If you
selected No, the display will return to the previous selection.
3. Press the ENTER key to accept the selection. If Yes was selected, the copy
process will start.
copy start
yes No
card>memorycopy
copying
Card -> Memory Copy
Program Y/N
card -> memorycopy
program y/n