Service manual

SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-28
Section 2. Configuration
LCD Panel — Service Mode
This selection specifies whether or not the printer will feed a blank label automatically when
an error condition is cleared..
Feed on Error
Yes No
feed on error
yes no
STEP PROCEDURE
1. Use the keys to step the cursor to either YES or NO.
If Yes is selected, the printer will feed a blank label anytime an error
condition is cleared.
2. Once the correct setting is selected, press ENTER to confirm the setting
and advance to the next display.
This selection specifies whether or not the printer will print the last printed label stored
in memory when the FEED key is pressed in the Normal Online mode.
Reprint W/Feed
Yes No
reprint w/feed
yes no
STEP PROCEDURE
1. Use the keys to step the cursor to either YES or NO.
If Yes is selected, the printer will reprint the last label when the FEED
key is pressed when the printer is Online. If the printer is Offline,
pressing a FEED key will feed a blank label.
2. Once the correct setting is selected, press ENTER to confirm the
setting and advance to the next display.
This display will only appear if Backfeed is enabled (DSW3-4 = OFF). The maximum
backfeed distance is 255 mm.
Forward/Backward
Distance Default
forward/backward
d i s t a n c e d e f a u lt