Service manual

PN 9001098
Rev. A
2-31
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
LCD Panel — Service Mode
This selection allows user to switch to assign a priority for Print Darkness, Print Speed
and Print Offset. Default value is COMMAND (Command Valid). If LCD is selected, the
setting established via the LCD display/menu system will be used for an incoming label
job, regardless of any different command settings. If Command is selected, any
commands in the label job will take precedence and be used for printing the job and the
LCD display will reflect the new setting.
Priority Setting
LCD Command
priority setting
command lcd
STEP PROCEDURE
1. Use the keys to select COMMAND (Command Valid) or
LCD (Command Invalid).
2. Once the correct setting is selected, press ENTER to confirm the
settingand advance to the next screen.
Label Re-Detect
Enable Disable
label re-detect
enable disable
STEP PROCEDURE
1. Use the keys to select the desired setting.
2. Once the correct setting is selected, press ENTER to confirm the
settingand advance to the next screen.
This selection allows user to switch to disable the feeding of a blank label upon power up.
If Enable is selected, the printer will automatically feed a label until it detects a label edge.
This will correctly position the next printed label under the print head. If Disable is
selected, the printer will not try to detect the next label and the operator is responsible for
ensuring that the label is correctly positioned before printing.
If the printer is placed in the Single Item Buffer Mode (DSW2-5 = ON), this selection allows
the user to set the width of the IEEE1284 ACK pulse. In the Multi-Item Buffer Mode, this
display will be skipped. The range is 0.5 µsec to 10 µsec.
IEEE1284
ACKSIGNAL 005
IEEE1284
ACKSIGNAL 005