Service manual

SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-32
Section 2. Configuration
STEP PROCEDURE
1. Use the keys to step the display to the desired setting. The setting
will advance in increments of 0.1 µsec each time the LINE key is pressed until the
setting reaches 10.0 µsec when it will wrap around to the 0.5 µsec setting.
2. Once the correct setting is selected, press ENTER to confirm the setting and
advance to the next screen.
To exit the Service Mode, power the printer off, then back on.
LCD Panel — Service Mode
IEEE1284
ACKSIGNAL 005
(Continued)
LCD Panel — Counters Mode
Advanced mode
counters mode
The Counters Mode is provided to allow the user to access the internal printer counters and is
entered from the Advanced Mode.
STEP PROCEDURE
1. From the Advanced Mode press the ENTER key, then press the key
to switch to the Counters Mode.
Counters
HD CUT LIFE
The counters are identified in the display as:
HD: Head Counter (should be reset when the print head is replaced)
CUT: Cutter Counter
LIFE: Life Counter (cannot be reset)
counters
hd cut life