Service manual

PN 9001098
Rev. A
2-33
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
STEP PROCEDURE
1. Use the keys to the desired counter. The default position is the
Head Counter.
2. Once the correct setting is selected, pressing ENTER will display the
current value (in meters) stored in the counter. The maximum number of
digits displayed is 8.
3. Press the ENTER key again to advance the counter to the Clear mode. All
counters with the exception of the LIFE counter will be cleared.
4. Use the cursor keys to select the desired setting. If you only want to read
the counter value, select NO. If you want to read the counter and reset it to
0.0, place the cursor over YES. Once the desired setting is selected, press
the ENTER key to advance to the next screen.
LCD Panel — Counters Mode
Counters
HD CUT LIFE
(Continued)
Cut Counter
0
cut counter
0
STEP PROCEDURE
1. Once the correct setting is selected, press ENTER to confirm the setting and
advance to the next screen.
Displays Cutter Counter
Selects Cutter Counter Clear. Default is NO (Do not Clear).
Cut Counter Clear
Yes No
STEP PROCEDURE
1. Use the keys to select YES (Clear) or NO (Do not Clear).
2. Once the correct setting is selected, press ENTER to confirm the setting and
advance to the next screen.
cut counter clear
yes No
counters
hd cut life
head counter
0.0m
Head counter clear
yes No