Service manual

SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-34
Section 2. Configuration
LCD Panel — CountersMode
Displays Life Counter
Life Counter
0.0M
life counter
0.0m
STEP PROCEDURE
1. Once the correct setting is selected, press ENTER to confirm the setting and
advance to the next screen.
To Exit the Counters Mode, power off the printer, then back on.
Counters
HD CUT LIFE
(Continued)
LCD Panel — Test Print Mode
The Test Print Mode offers four different printer status labels for troubleshooting. If DSW3-5
is in the OFF position, the Test Print cycle must be initiated with a Print Start signal on the
EXT connector. Enter the Test Print Mode by pressing the FEED key while powering on the
printer.
STEP PROCEDURE
1. Power on the printer while pressing the FEED key. Release the FEED key
after the beep sound and the printer will display the Test Print Mode message
on the LCD panel.
2. Use the keys to select the type of test label you wish to print.
The choices are: CONFIGURATION (setting content), BARCODE (bar
code), HEAD CHECK (head check), MEMORY (Expanded memory) and
FACTORY (factory test print).
3. Once you have selected the type of test label to be printed, press the ENTER
key to accept the selection and advance to the the Test Print Size display.
This display allows you to select the label width.
Test Print Mode
Configuration
test print mode
configuration