User's Manual Part 2

3PrinteroperationMediasensorcalibration
17
3 Printeroperation
Thischapterprovidesinformationaboutprinteroperation.
3.1 Mediasensorcalibration
Youwillwanttheprintertoworkproperlybeforestartingyourprintjobs.To
dothis,youneedtocalibrate themediasensor.WSprintersprovide
transmissiveandreflectivesensorcalibration.Takethefollowingstepsto
usethem.

1. Makesurethemediaisproperlyloaded,theprintmoduleisclosed,and
theprinter’spowerswitchissettotheOFFposition.
2. PressandholdtheFEEDbutton,andturnontheprinte r.
3. Bothstatuslightsglowsolidorangeforafewseconds.Next,theyturnto
greenshortly,andthenturntoothercolors.Dooneofthefollowingto
selectthesensor:
 Ifyouwanttocalibratethetransmissivesensor,whenLED1turnsto
greenandLED2turnstored,releasethe FEEDbuttonimmediately.
 Ifyouwanttocalibratethereflectivesensor,whenLED1turnstogreen
andLED2turnstoorange,releasetheFEEDbuttonimmediately.
4. PresstheFEEDbutton.Themediacalibrationiscompleteafterthe
printerfeeds3‐4labelsandstops.



