255GSA+++N User manual Freezer
CONTENTS Safety instructions Control panel Daily use Helpful hints and tips Care and cleaning 2 4 6 7 8 What to do if… 9 Installation 10 Noises 13 Technical data 14 Environmental concerns 15 Subject to change without notice. SAFETY INSTRUCTIONS In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
– avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a shortcircuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. • • • • 1. Power cord must not be lengthened. 2.
in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked are recyclable.
Important! If the door remains open for some minutes, the light will turn off automatically. The light is reset by closing and opening the door itself. Switching off To switch off the appliance do these steps: 1. Press the ON/OFF button for few seconds. 2. The display switches off. 3. To disconnect the appliance from the power disconnect the mains plug from the power socket. Temperature regulation The set temperature of the freezer may be adjusted by pressing the temperature button.
• flashing the alarm and freezer temperature indicators • sounding of buzzer. To reset the alarm: 1. Press any button. 2. The buzzer switches off. 3. The freezer temperature indicator shows the highest temperature reached for a few seconds. Then show again the set temperature. 4. The alarm indicator continue to flash until the normal conditions are restored. Door open alarm An acoustic alarm will sound if the door is left open for a few minutes.
Removal of freezing baskets and glass shelves from the freezer 2 1 The freezing baskets have a limit stop to prevent their accidental removal or falling out. At the time of its removal from the freezer, pull the basket towards yourself and, upon reaching the end point, remove the basket by tilting its front upwards. At the time of putting it back, slightly lift the front of the basket to insert it into the freezer. Once you are over the end points, push the baskets back in their position.
• the freezing process takes 24 hours.
Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. disconnect the appliance from electricity supply 2. remove all food 3. clean the appliance and all accessories 4. leave the door/doors open to prevent unpleasant smells. Important! If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.
Problem Possible cause Solution The room temperature is too high. Decrease the room temperature. The door is not closed correctly. Refer to "Closing the door". The door gasket is deformed or dirty. Refer to "Closing the door". The temperature in the appliance is too cold. The Temperature regulator may be set incorrectly. Set a warmer temperature. The temperature in the appliance is too warm. The Temperature regulator may be set incorrectly. Set a colder temperature.
Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Location To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 40 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. The ventilation space can be: • directly above the appliance • behind and above the top cupboard.
Spacers Install the spacers provided within the accessory bag on the back side of the panel. Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet using the adjustment spanner supplied. Door alignment is dependent on proper levelling. Door reversibility 2 1 4 3 To change the opening direction of the door, do these steps: • Remove the plug from the power. • Remove the ventilation grille. Remove the filling and install it on the opposite side of the grille.
• Remove the door. • Unscrew and move the pin to the opposite side. • Re-insert the door. • Re-screw the lower hinge. • Raise the appliance and install the ventilation grille. 2 1 • Unscrew the handle. On the opposite side remove the hole covers by driving a 3-4 mm drift or drill into them. • Install the handle. Fit the handle on to the opposite side by turning it on half circle. • Install the hole covers provided within the accessory bag. • Put the cabinet in position.
SSSRRR! HISSS! BLUBB! SSSRRR! HISSS! BLUBB! CLICK! CLICK! BRRR! CRACK! TECHNICAL DATA Dimension Height 1850 mm Width 660 mm Depth 680 mm Rising Time 16 h Voltage 230 V Frequency 50 Hz BRRR! CRACK!
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste.
Info Service Postfach 2550, 4002 Basel Info-Tel. 0848 888 444* www.coop.ch *Nationaler Tarif/Tarif national/Tariffa nazionale Servicestelle Wangen Postfach 4612 Wangen bei Olten Fax 062 206 33 12 Service après-vente Ch.