User manual

Service
• Any electrical work required to do the serv-
icing of the appliance should be carried
out by a qualified electrician or compe-
tent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban re-
fuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
are recyclable.
CONTROL PANEL
1 2 3 4 5
1 Green On/Off Indicator Light
2 Temperature Regulator and On/Off
Switch
3 Yellow Fast Freeze Indicator Light
4 Acoustic Signal Stop and Fast Freeze
Switch
5 Red Alarm Indicator Light
Switching on
1. Allow the appliance to stand for 4 hrs af-
ter installation.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clock-
wise to a temperature lower than << -
16 °C >> position.
4. The Green On/Off Indicator Light will
light up and Red Alarm Indicator Light
will blink.
5. The lighting up of the Green On/Off Indi-
cator Light means that the appliance is
switched on.
6. The blinking of the Red Alarm Indicator
Light means an improper temperature in
the freezing compartment. In addition,
an intermittent sound can be heard,
which can be stopped by pressing the
Acoustic Signal Stop and Fast Freeze
Switch once.
7. When switching on the freezer for the
first time, the Red Alarm Indicator Light
will blink until the internal temperature
has reached a level required for the safe
conservation of frozen food.
Switching off
1. To turn off the appliance, turn the Tem-
perature Regulator to the "O" position.
2. To disconnect the appliance from the
power disconnect the mains plug from
the wall socket.
Temperature regulation
The temperature within the appliance is con-
trolled by the Temperature Regulator situ-
ated on the control panel.
To operate the appliance, proceed as fol-
lows:
• turn the Temperature Regulator toward
lower settings to obtain the minimum cold-
ness.
• turn the Temperature Regulator toward
higher settings to obtain the maximum
coldness.
A medium setting is generally the most
suitable.
19) If a water connection is foreseen
40