Owner`s manual

Connections
Connecting
the
FM
and
AM
antennas
Connecting
the
power
cable
Ground (GND terminal)
The
GND
terminal is not
for
earth grounding.
To
reduce noises, connect a ground bar
or
a
vinyl-eovered wire with a copper plate at its tip,
and place
it
in the
moist
ground.
An
indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Power cable
To
the
AC
wall outlet
\
.......
::.
",1~~
'·~C}~\
~J.,1
'''.l'i''J:fiO<l;''
,
'0-:
.....
__
.....
After all connections are complete, plug the power cable
of
this unit into
an
AC wall outlet.
I
J
AM
loop
antenna
Outdoor
AM antenna
Connect a 5
to
10 m (16
to
33
tt)
vinyl-covered wire,
and extend
it
outdoors
(use the
AM loop antenna
together with
this
antenna).
Indoor
FM antenna
'"
~<i>-:
The supplied antennas are normally sensitive enough to obtain good
reception.
Position the AM loop antenna away from this unit.
If
you cannot get good reception, we recommend that you use an outdoor
antenna. For details, consult the nearest authorized Yamaha dealer or
service center.
Always use the AM loop antenna even when the outdoor antenna is
connected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires
of
the AM loop antenna have no polarity.
You
can connect either wire
to
the AM terminal and the other
to
the GND terminal.
Turning
this
unit
on
and
off
1 Press
®MAIN
ZONE
ON/OFF
on the front
panel (or
IlIDPOWER
on the remote control)
to turn on this unit.
2 Press
®MAIN
ZONE
ON/OFF
(or
IlIDPOWER)
again to turn off this unit
(standby mode).
'"
~<i>-:
The unit needs a few seconds until ready to play back.
You
can also tum on this unit
by
pressing
®SCENE
(or [IDSCENE).
This unit consumes a small amount
of
electricity even in the standby
mode.
We
recommend disconnecting the power cable from the
AC
wall
outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
mayilamage this unit or cause the settings
of
this unit
to be saved incorrectly.
Press and hold
Insert Release
18
En