Owner`s manual

Opt mizing the speaker setting for your listening room (YPAO)
This unit has a Yamaha Parametric Acoustic Optimizer (YPAO). With the YPAO, this unit automatically adjusts the
output characteristics
of your speakers based on speaker position, speaker performance, and the acoustic characteristics
of the room. We recommend that you first adjust the output characteristics with the YPAO when you use this unit.
Connect the supplied optimizer microphone
to the @OPTIMIZER MIC jack on the front
panel.
Optimizer microphone
3 Place the optimizer microphone at your
normal listening position on a flat level
surface with the omni-directional
microphone heading upward.
'"
~<i>~
• You can bring up the above menu screen from the Setup menu (page 55).
~ Optimizer microphone
"MIC ON. View QUI MENU" appears on the front panel
display.
The QUI screen appears on the video monitor.
2
uto Setup
,"
~<i>~
• You can manually adjust the output characteristics of your speakers
with "Manual Setup" in the Setup menu (page 55).
Subwoofer
Caution
• Be advised that it is normal for loud test tones to be
output during the "Auto Setup" procedure. Do not
allow small children to enter the room during the
procedure.
•
To achieve the best results, make sure the room is as
quiet as possible while the "Auto Setup" procedure is
in progress.
If there is too much ambient noise, the
results may not be satisfactory.
CROSSOVER!
VOLUME HIGH CUT
t(). ·0
MIN MAX MIN MJ
~
1 Check the following points.
Before starting the automatic setup, check the
following.
• All speakers and subwoofer are connected
properly.
• Headphones are disconnected from this unit.
• The video monitor is connected properly.
• This unit and the video monitor are turned on.
• This unit is selected as the video input source
of the
video monitor.
• The connected subwoofer is turned on and the
volume level is set to about half way (or slightly
less).
• The crossover frequency controls
of the connected
subwoofer are set to the maximum.
,',
~<i>~
• It is recommended that you use a tripod or something similar to fix the
optimizer microphone at the same height as your ears would be when
seated in your listening position.
You can fix the optimizer microphone to
the tripod with the attaching screw of the tripod.
I
19 En