Owner`s manual

When n error message is 'displayed
during' easurement
If an error is detected during measurement, the
measurement is canceled and "Error" appears on the GUI
screen. Check the error and solve the problem. For details
on each error message, see page 75.
Press IIQICursor Vonce, press IIQICursor <:J / l>
to select "Retry" or "Exit" and then press
IIQIENTER.
Retry
Performs "Auto Setup" again.
Exit
Terminates the measurement and "Auto Setup".
'"
~'i>~
• When "E-5:NOISY" appears, you can continue measurement. To
continue measurement, select "Proceed". However, we recommend that
you solve the problem first and then perform measurement again.
warning messli'ge is displayed
easurenUent .
;
If a problem occurs during measurement, "Check xx
warning(s)" appears on the GUI screen. Check the
warning and solve the problem. For details on each
warning message, see page 76.
'"
~'i>~
• Optimization will not be performed while a warning message is
displayed.
We recommend that you solve the problem and perform "Auto
Setup" again.
1 Press IIQICursor V/ 6. to select "Check xx
warning(s)" and then press
IIQIENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using
IIQICursor l>.
2 To return to the top result display, press
IIQIENTER again.
Optimizing the speaker setting for your listening room (YPAO)
21 En
I