Owner`s manual

Playback
3 Press llIDENTER.
,',
:<i>:'
• If an input source you want to select is available in "Select Scene", you
can select the desired input source and sound field program
at once.
Registering input source/sound field
program
Select the desired input source/sound field
program and then press and hold
®SCENE (or
@SCENE) key to edit until "SET Complete"
appears on the front panel display.
,"
:<i>:'
• If you change the input source setting, register the remote control code of
an external component to the input source (page 63).
Category
Select Media
Select Input
Input source
USB, DOCK, SIRIUS, XM,
TUNER, PHONO, V-AUX,
MULTICH
HDMIl-4, AVI-6, AUDIO 1/2
Switching remotely controlled external
components linked to scene selections
I
Tr·eb 11:::
Notes
Use Pure Direct mode to enjoy the pure high fidelity
sound
of the selected source. When Pure Direct mode is
activated, this unit plays back the selected source with the
least circuitry.
You can adjust the balance of the high frequency range
(Treble) and low frequency range (Bass)
of sounds output
from the front left and right speakers to obtain desired
tone.
• The tone control settings are not effective when this unit is in the Pure
Direct mode or "MULTI CH"
is selected as an input source.
• If you set the balance extremely off, sounds may not match those from
other channels well.
2 Rotate the @PROGRAM selector to adjust
the frequency range.
Control range:
-10.0 dB to +I0.0 dB
The display returns to the previous screen
automatically
in few seconds.
2 Press [WMUTE again to resume audio
output.
1 Press ~TONE CONTROL on the front panel
repeatedly to select "Treble" or "Bass".
The current setting is displayed on the front panel
display.
1 Press [WMUTE on the remote control to mute
the audio output.
The MUTE indicator on the front panel display
flashes while audio output is muted.
Input source
BDIDVD, TV, CD, RADIO
Category
Select Scene
2 Use llIDCursor fj, / Vrepeatedly to switch the
page and
llIDCursor <J / [> repeatedly to
select the desired input source.
2 While holding down the desired [IDSCENE
key, press and hold the @]Input selection
key to which you registered a remote control
code
in step 1.
From now on the external component can be remotely
controllable just by selecting a scene.
1 Press rnJON SCREEN on the remote control.
The GUI screen appears on the video monitor.
You can operate an external component with the remote
control
of this unit by setting a remote control code for the
external component for each input source. Setting remote
control codes for desired input sources allows you to
switch between external components linked to scene
selections.
1 Register the remote control code of an
external component to the desired input
source (page 63).
Note
• This feature is not available for TUNER, SIRIUS and XM input
sources.
mml
Ei
23 En