Owner`s manual
•
Using
multi-zone
configuration
This unit allows you to configure a multi-zone audio system. This feature allows you to set this unit to reproduce separate
input sources in the main zone and the second zone (Zone2).
You
can control this unit from the second zone using the
supplied remote control.
Only analog signal can be sent to the second zone.
If
you want to output sounds to Zone2, connect an external
component to the AV5-6, AUOIOI-2 or VIDEO AUX (AUDIO) jacks (by analog connection). For example,
if
you
want to output sound from an HOMI OVO player to the second zone, you must connect the HOMI OVO player to this
unit
by
both HOMI and analog connections.
Using the internal amplifier of this unit
This
unit
Second zone
(Zone2)
Important safety notice
The EXTRA SP terminals
of
this unit should not be
connected
to
a Passive Loudspeaker Selector Box or
more than one loudspeaker per channel.
Connection
to
a Passive Loudspeaker Selector Box or
multiple speakers per channel could create an
abnormally low impedance load resulting in amplifier
damage. See this owner's manual for correct usage.
Compliance with minimum speaker impedance
information for all channels must be maintained at all
times. This information
is
found on the back panel
of
your unit.
Connect the speakers in the second zone to the EXTRA
SP terminals and then set "Extra Speaker Assignment" to
"Zone2" (page 56).
c;;;;JJ
~
Q
Amplifier
Second zone
(Zone2)
From
the
ZONE2
OUT
jacks
lIIIain zone
Connect an amplifier/receiver in the second zone and
other components to this unit as follows.
Using an external amplifier
,0,
~<i>~
• Since there are many possible ways
to
connect and use this unit in a
multi-zone configuration,
we
recommend
that you consult with your
nearest authorized Yamaha dealer
or
service center about the Zone2
connections that best meet your requirements.
•
Some
Yamaha models
can
be directly connected to the
REMOTE
jacks
of
this unit. You may not need use an infrared signal emitter for these
products. Up to 6 components
can
be connected using monaural analog
mini cables
or
via an
IR
flashers. For details about connections, see
"Transmitting/receiving remote control signals" (page 17).
You
need the following additional equipment to use the
multi-zone functions
of
this unit:
• An infrared signal receiver in the second zone.
• An infrared signal emitter in the main zone. This emitter
transmits infrared signals from the remote control to a
CO player or a OVO player, etc. in the main zone via
the infrared signal receiver in the second zone.
• An amplifier and speakers in the second zone.
Main zone
,0,
~<i>:'
• You
can
use the speakers connected to
EXTRA
SP
terminals as the front
speaker system
of
another zone.
•
When
you use the internal amplifiers for the Zone2 speakers,
you
can
adjust the volume level
and
set the initial volume and
maximum
volume
of
the Zone2 speakers (page 60).
Infrared
signal
receiver
c::::J)
) ) )
Remote
control
~
~7Infrared
signal
emItter
U
DVD
player
(etc.)
C=:J-
This
unit
,
,
,
L-
:
---'
,
From
the
REMOTE
OUT
jack
To
the
REMOTE
IN
jack
Note
• To avoid unexpected noise,
DO
NOT
USE the Zone2 feature with
CDs
encoded in DTS.
I
61
En