Owner`s manual

Problem Cause
Remedy
Troubleshooting
See
page
The picture
is
disturbed.
The video software is copy-protected.
No sound.
Only the center
speaker
outputs
substantiill sound.
No sound
is output
from a spl!cific
speaker.
Incorrect input or output cable
connections.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down or muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The HDMI components connected to this
unit do not support the HDCP copy
protection standards.
"Audio Output" in "HDMI" is set to
"TV".
A proper audio decoder is not selected.
When a monaural source sound field
program is applied, sound
of all channels
are output from the center speaker for
some surround decoders.
The playback component or speakers are
not connected properly.
Output from that speaker is disabled.
The volume
of that speaker is set to
minimum
in "Speaker Setup" in the
"Setup" menu.
This unit is in the straight decode mode.
Sound may not
be output from certain
channels depending on input sources
or
sound field programs.
The speaker is malfunction.
Connect the cables properly.
If the problem persists,
the cables may be defective.
Rotate
the@INPUT selector (or press I4Jlnput
selection key) to select the desired input source.
Secure the connections.
Turn up the volume.
Display "Signal Info"
in the Option menu and check
the input signal format.
If "No Signal" is displayed, check if the playback
component is properly connected to this unit (or a
proper input source is selected).
If "_" is displayed, the input signal in that format
cannot be reproduced
by this unit.
Connect HDMI components that support the HDCP
copy protection standards.
Set "Audio Output" (Function Setup
---t HDMI ---t
Audio Output) to the other setting.
Display the Option menu and set "Decoder Mode" to
"Auto".
Try another sound field program.
Connect the cables properly.
If the problem persists,
the cables may be defective.
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
I) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) "None" may have been selected for that speaker on
this unit. Display "Speaker Setup"
in the "Setup"
menu and enables output
of that speaker.
Display "Speaker Setup" in the "Setup" menu and
adjust the volume (Manual Setup
---t Speaker Level).
Press@STRAIGHT (or rnSTRAIGHT) to turn
off the straight decode mode.
Try another sound field program.
Check the speaker indicators on the front panel
display.
If the corresponding indicator lights up,
connect another speaker and check if sound
is output.
If sound is not output, this unit may be malfunction.
15
22
II
22
81
58
47
25
12,15
6,22,25,
55
57
28
25
67 En
I