Operation Manual

SCP-9000

POWERPROF

Danger and Live Parts Within.

Always unplug the vacuum from mains

power supply before dismantling any part

of the machine. The vacuum cleaner powerhead

contains electrical connections. The vacuum cleaner

powerhead is not a serviceable part.

Removing the Brush Roller: To remove the brush roller,

press the button marked “PRESS” (9) and turn the bearing

(8) downward. Turn the brush (24) quickly to the right and

pull it out. We recommend regular removal of threads and

hair which have wound around the brush roller.

Removing Blockages: If you can only feel a small amount

of suction or the brush is not functioning correctly there might be a blockage.

Please refer to your vacuum cleaner manual ﬁrst and have a look at the Removing Blockages

section. Check the swivel neck of the powerhead and the orange trap-door (11) on the

bottom of the powerhead. Also check between these two openings in the powerhead.

Start at setting 4 on the height adjuster (2) and adjust

according to the indicator light (6+7). The electronic

brush control constantly monitors the status of the brush,

communicating the status through the lights on top.

Green (7) and red (6): The brush is not fully engaged in

the carpet. The height adjustment should be lowered. If the

height adjustment is at its lowest setting, the brush is worn and needs to be replaced.

This detail applies only to carpet.

Green light only (7): Brush is working well. We strongly recommend in normal use

selecting a brush height that is only one level beneath that at which both the green and

red lights are on. For maximum cleaning performance, the brush height adjustment can

be lowered to its lowest setting.

Red light only (6): The brush is blocked. (see below Removing Blockages) Turn off the

machine, unplug it, and then remove the blockage.

To clean delicate ﬂoor surfaces the powerhead is equipped with an on/off switch. When

this switch is used to turn off the brush roller the indicator lights (6+7) are also turned off.

Maintenance

Selecting the correct brush height