Instructions / Assembly

Step Step 9
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (G) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (G).
Push on opposite corners of your unit if needed to make
it "square".
å
Using your hammer, fasten the BACK (G) to your unit
using the NAILS (12).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the UPRIGHT (C) and SHELF (F).
å
With a hammer, gently tap four TACK GLIDES (19) into the
ENDS (A and B).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(40 used in this step)
12
Page 13
www.sauder.com419636
G
Unfi nished
surface
These holes must line up over
the UPRIGHT (C) and SHELF (F).
19
A
B