Instructions / Assembly

Step 11
å
Insert the dowel end of two TWIST-LOCK® FASTENERS (JJ) into the TOP (E2) as shown in the enlarged diagram.
å
NOTE: If you already pushed TWIST-LOCK® FASTENERS into the large holes in the BACKS (G), pull the FASTENERS back
out of the holes. Pull at the front and back edges, slowly working the FASTENERS out of the holes.
å
1. At an angle, push the long edge with holes in the BACKS (G) onto the CAM SCREWS in the LEGS (J).
å
2. Now, swing in the opposite long edge of the BACKS (G) so the TWIST-LOCK® FASTENER in the TOP (E2) pushes into
the large holes in the BACKS. Tighten two TWIST-LOCK® FASTENER and four HIDDEN CAMS.
å
Fasten the BRACES (H) to the UPRIGHTS (C and D). Tighten four HIDDEN CAMS.
409042 www.sauder.com/servicesPage 16
C
D
E2
G
H
G
H
JJ
J
J
These holes must be here.
These holes must be here.
Unfi nished
surface
These holes must be here.
These holes must be here.
E2
G
Unfi nished
surface
Surface with
HIDDEN CAMS
Surface with
HIDDEN CAMS
1. Push this long
edge over the
CAM SCREW.
2. Swing this
edge in over the
TWIST-LOCK®
FASTENER.