Instructions / Assembly

å
Turn the HUTCH DRAWER BOX over onto its top.
å
Slide the HUTCH DRAWER BOTTOM (EE) underneath the
METAL BRACKETS (WW).
å
Make equal margins along two short edges of the HUTCH
DRAWER BOTTOM (EE). Be sure the HUTCH DRAWER BOTTOM
is against the METAL BRACKETS. Push on opposite corners of
your box if needed to make it "square".
å
With a hammer, fasten the HUTCH DRAWER BOTTOM (EE) to
the HUTCH DRAWER SIDES (Y) and HUTCH DRAWER BACK (Z)
by tapping in the TACK GLIDES (YY) through the holes shown.
å
Finish fastening the HUTCH DRAWER BOTTOM (EE) to the
HUTCH DRAWER SIDES (Y) and HUTCH DRAWER BACK (Z)
using the NAILS (RRR).
Step 18
409043www.sauder.com/services
Page 23
NAIL
(6 used in this step)
RRR
YY
EE
EE
YY
Notches
WW
Y
Y
Z