Instructions / Assembly

å
Carefully turn your unit over onto its front edges. Unfold
the BACK (I) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (I).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (I) to your unit using the NAILS (FF).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the UPRIGHTS (C and D).
å
NOTE: Perforations have been provided for access
through the BACK. Carefully cut out the holes needed.
Step 10
410847www.sauder.com/services
Page 15
I
These holes must line up over the UPRIGHTS.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi nished surface
NAIL
(38 used in this step)
FF