Instructions / Assembly

Step 6
411222 www.sauder.com/servicesPage 10
Arrow
Minimum
190 degrees
Maximum
210 degrees
C3
I3
Surface with
HIDDEN CAMS
These holes
must be here.
Roller end
15F
15F
å
First, fi ll the hole in the short edge of the UPRIGHT (C3) 1/4 to 1/2
full with GLUE (54M). Then, insert a WOOD DOWEL (15F) into the
hole. Wipe away the excess GLUE.
å
Next, fi ll the two holes in the other short edge of the UPRIGHT (C3)
1/4 to 1/2 full with GLUE. Then, insert two WOOD DOWELS (15F)
into these holes. Wipe away the excess GLUE.
å
Now, fi ll the holes in the BACK PANEL (I3) 1/4 to 1/2 full with
GLUE. Be sure to fi ll the second and fourth holes from the top
edge as shown.
å
Fasten the UPRIGHT (C3) to the BACK PANEL (I3). Tighten two
HIDDEN CAMS. Wipe away the excess glue.
å
NOTE: Be sure the WOOD DOWELS in the UPRIGHT insert into
the holes in the BACK PANEL.
54M
Fill the holes 1/4 to 1/2 full with GLUE.
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely di cult.
Caution
!