Instructions / Assembly

å
First, fi ll the holes in a short edge of the BACK PANEL (I3) 1/4 to
1/2 full with GLUE (54M). Then, insert two WOOD DOWELS (15F)
into the holes. Wipe away the excess GLUE.
å
Next, fi ll the holes in the other short edge of the BACK PANEL (I3)
1/4 to 1/2 full with GLUE. Then, insert two WOOD DOWELS (15F)
into these holes. Wipe away the excess GLUE.
å
Now, fi ll the holes in the RIGHT END (E3) 1/4 to 1/2 full with GLUE.
Be sure to fi ll the second and fourth holes from the rounded edge
as shown.
å
Fasten the RIGHT END (E3) to the BACK PANEL (I3). Tighten two
HIDDEN CAMS. Wipe away the excess glue
å
NOTE: Be sure the WOOD DOWELS in the BACK PANEL insert
into the holes in the RIGHT END.
Step 5
411222www.sauder.com/services
Page 9
Start Tighten
Arrow
Minimum
190 degrees
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Arrow
Maximum
210 degrees
E3
I3
Right End
Rounded edge
Roller end
Fill the holes 1/4 to 1/2 full with GLUE.
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely di cult.
Caution
!
54M
15F
15F
Surface with HIDDEN CAMS