Instructions / Assembly

Step Step 10
å
Carefully turn your unit over onto its front edges. Unfold the BACK (F)
and lay it over your unit.
å
Make equal margins along three edges of the BACK (F). The BACK will
overhang the BOTTOM (E) slightly. Push on opposite corners of your
unit if needed to make it "square".
å
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHT (C2).
å
NOTE: Perforations have been provided for access through the BACK.
Carefully cut out the holes needed.
å
Push the FOOT (3E) into the hole in the BOTTOM (E).
å
Fasten the TIE PLATES (3G) to the BASE (H) and PLINTHS (R2). Use
four BLACK 9/16" LARGE HEAD SCREWS (1S).
411830www.sauder.com/services
Page 15
E
F
H
3E
3G
R2
R2
Cut-out (used for mirror)
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
1S
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(60 used in this step)
1N
These holes must line up
over the UPRIGHT (C2).
Th BACK will overhang
the BOTTOM slightly.
Printed information
must be facing up.