Instructions / Assembly

å
Carefully stand your unit upright.
å
Position your unit in its fi nal location. Turn the ADJUSTABLE FEET (JJ) downward
until they touch the fl oor.
å
IMPORTANT: The ADJUSTABLE FEET should not extend beyond the bottom edges of
the SIDE SKIRTS (R).
å
NOTE: To raise a corner of the unit, turn the ADJUSTABLE GLIDE counter-
clockwise. To lower a corner, turn the ADJUSTABLE GLIDE clockwise.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against
the stops as shown in the left diagram. If it isn't, loosen the mounting screw to
slide it against the stops. Then tighten the mounting screw.
å
Fasten the LARGE DOOR (L) to the LARGE END (B) as shown in the lower
diagram. Use the screws in the HINGES. You should start each SCREW a few
turns before completely tightening any of them.
å
Fasten a PULL (X) to the LARGE DOOR (L). Use two BLACK 7/8" MACHINE
SCREWS (NN).
å
See the next step for DOOR adjustments.
Step 13
LARGE DOOR ON LEFT
Mounting
screw
Stop
Hinge
BLACK 7/8" MACHINE SCREW
(2 used for the PULL)
NN
X
B
L
411965www.sauder.com/services
Page 17
Turn the ADJUSTABLE FEET
downward until it touches the fl oor.
JJ
Floor
R