Instructions / Assembly

å
NOTE: Stand the UPRIGHT (D) in place to be sure you are
drilling through the correct holes in the TOP (E).
å
There are four pre-drilled holes in the top surface of the
TOP (E). Finish drilling out two holes with your electric
drill and 1/4" drill bit.
å
Fasten the UPRIGHT (D) to the TOP (E). Use two BLACK
1-7/8" FLAT HEAD SCREWS (MM).
å
Fasten the UPRIGHT (D) to the LARGE SHELF (I). Tighten
two TWIST-LOCK® FASTENERS.
Step 3
LARGE DOOR ON LEFT
Find the correct pre-driled holes that
line up with the UPRIGHT (D) and drill
through the top surface of the TOP (E).
These four holes must be here.
E
I
D
411965www.sauder.com/services
Page 7
BLACK 1-7/8" FLAT HEAD SCREW
(2 used in this step)
MM
34-3/4"
34-3/4"
The measurement must be as shown. If it is
not, then fl ip the UPRIGHT (D) end for end.