Instructions / Assembly

å
Carefully turn your unit over onto its front edges. Lay the
BACKS (EE and FF) over your unit.
å
Make equal margins along the bottom and both side
edges of the BACKS (EE and FF). Push on opposite
corners of your unit if needed to make it "square".
å
Fasten the BACK (EE and FF) to your unit using
the NAILS (RRR).
Step 13
412116www.sauder.com/services
Page 19
EE
FF
Finished surface
Finished surface
Edge without holes
NAIL
(33 used in this step)
RRR
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution