Instructions / Assembly

Step 2
å
Separate the EXTENSION SLIDES (II) from the
EXTENSION RAILS (HH) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (HH) to the SMALL RIGHT
END (C) and SMALL UPRIGHT (E). Use four GOLD 5/16"
FLAT HEAD SCREWS (QQQ).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL out to fi nd the
other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
412116 www.sauder.com/servicesPage 8
Push the black lever in and pull the SLIDE from the RAIL.
II HH
C
E
HH
HH
Finished edge
Open end
Finished edge
Open end
Surface with
HIDDEN CAMS
Surface with
HIDDEN CAMS
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
QQQ
Remember:
Righty tighty.
Lefty loosey.