Instructions / Assembly

å
Carefully turn your unit over onto its front edges. Unfold one of
the BACKS (I) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (I). Push
on opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (I) to your unit using the NAILS (1N). Do not
fasten the edge that lays over the UPRIGHT.
å
Next, fasten the other BACK (I) to your unit using the NAILS.
The BACKS will overlap each other. See the enlarged diagram.
å
NOTE: Be sure to tap NAILS into the holes that line up over the
UPRIGHTS (D and E) and SHELVES (H).
Step 11
414726www.sauder.com/services
Page 15
I
I
These holes must line up over
the UPRIGHTS and SHELVES.
I
I
Unfi nished
surface
Unfi nished
surface
NAIL
(91 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution