Instructions / Assembly

å
Carefully turn your unit over onto its front edges. Lay the BACK (E)
over your unit.
å
Make equal margins along all four edges of the BACK (E). Push on
opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (E) to your unit using the NAILS (1N).
Step 9
415050www.sauder.com/services
Page 13
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(20 used in this step)
1N
E
Printed information
must be facing up.
This hole should be
over the screw head.