Instructions / Assembly

å
Carefully turn your unit over onto its front edges. Lay the
DESK BACK (H) over your unit.
å
Make equal margins along all four edges of the DESK
BACK (H). Push on opposite corners of your unit if needed
to make it “square”.
å
Fasten the DESK BACK (H) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the DESK SHELF (G).
å
NOTE: Perforations have been provided for access
through the BACK. Carefully cut out the holes needed.
Step 6
415817www.sauder.com/services
Page 9
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
These holes must line up
over the DESK SHELF (G).
NAIL
(20 used in this step)
1N
This perforation must be closer to
the bottom edge of the BACK (H).
H