Instructions / Assembly

Step Step 24
å
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
å
Fasten the DOOR (H) to the HINGE UPRIGHT (D) as
shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten a PULL (113K) to the DOOR (H). Use two BLACK
7/8" MACHINE SCREWS (37S).
å
Repeat this step for the other DOOR (H).
å
See the next step for DOOR adjustments.
Mounting
screw
Stop
Hinge
H
418142www.sauder.com/services
Page 29
Hey! It's starting to look
like something!
BLACK 7/8" MACHINE SCREW
(4 used in this step)
37S
113K
D