Instructions / Assembly

Step 12
418295 www.sauder.com/servicesPage 16
å
Unfold the LEFT BACK (G) and lay it over your unit.
å
Make equal margins along the top and outer edge of the
LEFT BACK (G). Push on opposite corners of your unit if
needed to make it “square”.
å
NOTE: The LEFT BACK (G) will overlap the RIGHT BACK (F).
Follow the enlarged diagram.
å
Fasten the LEFT BACK (G) to your unit using three BLACK
9/16" LARGE HEAD SCREWS (1S) into the holes shown in
the LEFT BACK. Use fi fteen NAILS (1N) into the top and
both side edges.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(15 used in this step)
1N
F
G
G
F
The LEFT BACK (G) will
overlap the RIGHT BACK (F).
BLACK 9/16" LARGE HEAD SCREW
(3 used in this step)
1S
Do not tap NAILS into
the bottom row of holes.
Notch