Instructions / Assembly

å
IMPORTANT: You will need someone's help in this step.
å
Fasten the TOP (D) to the ENDS (A and B). Use two BUSHINGS (91M) and two BLACK 3/4" PAN HEAD SCREWS (85S)
through the exact holes shown in the LIFT TABLE MECHANISMS (23M) and into the holes in the ENDS.
å
NOTE: Do not overtighten the SCREWS (85S).
å
Then, fasten the TOP (D) to the ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S) through the LIFT
TABLE MECHANISMS (23M) and into the remaining holes in the ENDS.
å
NOTE: Be careful when lining up the holes in the MECHANISMS
with the holes in the ENDS as to not damage any parts.
You should start each SCREW a few turns
before completely tightening
any of them.
Step 17
420421www.sauder.com/services
Page 21
23M
23M
D
B
A
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
1S
91M
These four holes
must be here.
BLACK 3/4" PAN HEAD SCREW
(2 used for the BUSHINGS)
85S
85S
91M
Do not overtighten
the SCREWS (85S).