User guide

29
Test the sauna and take
safety measurements
When the installation is done and you have run through
all the steps in the checklist, the only thing that remains
is to test the sauna and take the safety measurements
required. The object of the testing is to discover if
there are any faults in material or installation.
Check the following when testing
1. That the display of the control panel is working.
2. That all the heating elements are warming up.
3. That ventilation and lighting work when activated.
The last step of the
checklist is to test the
sauna and run through
the required safety
measurements.
Program the control panel
The basic settings are to be done by the
installer. They include setting the clock and
choosing the language. After a power
failure of more than 20 minutes the basic
settings are deleted. In that case the user
must reset the basic settings.
Instructions to program the basic
settings of the control panel are to
be found on page 8.
The installer must set the basic
settings. They are found at page 8.
Information to the installer