Technical information

52
Diagram 13.10
SECURING SCREWS
12594
USER
INTERFACE
13.22 Main PCB
For access, refer to section 13.1
Hinge down the control box, see diagram 13.11.
Remove TORX screws and unhook the rear
panel.
Remove the electrical connections to the PCB.
Prise back the two PCB retaining clips and
withdraw the PCB.
When refitting the rear panel ensure the leads
are not trapped.
13.23 Control Box
For access refer to section 13.22.
Remove relevant plugs and connectors, refer to
wiring diagram 12.2.
Withdraw grommets and leads so they are
hanging loose.
Unthread the retaining strap and remove the
control box by drawing it outwards away from its
retaining slots, see diagram 13.11.
13.24 Fuse - Main PCB - Control Box
For access, refer to section 13.22.
The fuse is located at bottom right hand side of
the PCB, see diagram 12.2 or 13.1.
13.25 230V Controls Interface
For access, refer to section 13.18.
Disconnect the electrical connection from the
230V controls interface board and the electrical
connection from the main PCB, see diagram
13.12.
Remove the 230V controls interface retaining
screw.
Remove the 230V controls interface board.
Diagram 13.11
12597
CONTROL PANEL
RETAINING
STRAP
RETAINING
SLOT
Diagram 13.12
USER
INTERFACE
BOARD
230V
CONTROLS
INTERFACE
BOARD
12615