User Manual

Group 1
①Main ON Switch
②Main OFF Switch
③Brightness+
④Brightness-
⑤ON
⑥OFF
①
②
③
④
⑤
⑥
Group 1
Group 2
Group 3
Group 4
Group 2 Group 3 Group 4
Instructions
Remote Control
LED-60K-R 500 Watt
LED Studio Light Kit
www.savageuniversal.com
Group matching
Step 1: While the socket is in the off position, press the (5) button for 5 seconds. Continue to press while going to Step 2..
Step 2: Switch the lamp socket to the on "ON" position. If the LED bulb flashes, it has been successfully paired with the remote
control. Remove finger from the (5) button. The (5) button will now be the "ON" switch for that bulb and the (6) switch will be the
"OFF" switch
Step 3:: Repeat the above steps with the second LED bulb using the buttons marked "Group 2" in the above illustration.
Step 4: The remote control can also be used to pair up to 2 extra bulbs sold separately.
Unpairing LED bulb
To unpair,repeat the above"Group matching"steps with a paired bulb.
Operation
Step 1: Use button (5) to turn on the paired bulb.
Step 2: After the light has been selected and turned on, use button (3) to brighten and button (4) to dim the bulb.
Step 3: After the light has been turned off using the remote control, the bulbs fan will remain running. Turn the switch on the lamp
socket to the 'OFF" position to turn the fan off. No cool down time is necessary.
Step 4: To remove the clear dome, screw counterclockwise until the dome separates from the bulb. If you prefer a warmer light,
add the orange dome by screwing to the front of the bulb in a clockwise direction until snug. Add the blue dome to add blue
special effect.