Setup Manual

ManualsBrandsSAVEO ManualsPOS EquipmentBarcode Scanner with Bluetooth

V4SetupManual

GettingStarted:

Pressingthescantrigger.Thescannerwillbeturnedonwith1timebeeping.V4

Canceledthephysicalswitch,Micro‐BandType‐Cmobilephonecanbeconfigured

throughscanningthesettingcode.



1.USBTypeSwitch：



2、Charge/DataTransmissionautoswitch:

Whenadaptercableinputorputintochargingcradle,thescannerwillbeepasound

andconfigureaschargingmode,otherwise,ScannerconfigureasDataTransmission

mode.TheUSBChargingorDataTransmissionconfigure(Micro‐B,Type‐C)according

toreadthememoryset.



ScanbelowbarcodeswitchtoMICROBmode.

MicroB(Default)



ScanbelowbarcodeswitchtoTYPECmode.

TYPEC  .



Note: After setting the USB type, scanner will restart, please push the trigger for cell phone

enumerateagain.

Summary of content (8 pages)

PAGE 1
V4 Setup Manual Getting Started: Pressing the scan trigger . The scanner will be turned on with 1time beeping.V4 Canceled the physical switch, Micro‐B and Type‐C mobile phone can be configured through scanning the setting code. 1.USB Type Switch： Scan below barcode switch to MICRO B mode. Micro B (Default) Scan below barcode switch to TYPE C mode. TYPE C .
PAGE 2
3、USB/Bluetooth Transmission switch： When device USB cable was connected and enumerate success, Scanner transmit data by USB cable. Device USB cable was disconnected, or Scanner in Charging mode, Scanner transmit data by Bluetooth.
PAGE 3
Important Note: 1. Scanner will power off automatically if device is not connected within 1min. 2. If you want to shift from HID to SPP or BLE just scan the Corresponding command barcode. If you want to shift from SPP or BLE to HID mode, first ignore (or delete) "Netum Bluetooth"→ turn oﬀ bluetooth→ scan command barcode of HID→ Open the bluetooth → repair it. 4.
PAGE 4
5.LED Indicators Identity Charge LEDs LED Color RED，GREEN Indication Charging: Red on, Green off. Charge done: Red off, Green on. At Bluetooth transmit mode: Bluetooth linked: Blue ON. Bluetooth LED BLUE Bluetooth not link: Blue flashing. At Wired USB transmit mode: Blue OFF. ON when normal speaker sound(In any mode). Battery low volume(Red flashing, when it less than 15%(0.7s Alarm LED RED interval), 8%(0.3s interval). Red flashing when alarm sound.
PAGE 5
7.
PAGE 6
8、Power management Sleep immediately(It not setting code) Sleep time set Sleep time=30s *Sleep time=1min Sleep time=3min Sleep time=6min Sleep time=12min Sleep time=30min Sleep time=1hour Sleep time=2hours Never Sleep
PAGE 7
9.IOS keyboard Popup IOS Popup/Hide Keyboard(Bluetooth) Scan this barcode or Hold trigger 4 seconds at Bluetooth connected state on IOS device, popup IOS keyboard. 10. Transmission Interface Setting USB COM Mode Bluetooth SPP USB HID Bluetooth HID Scan Un‐pair at Bluetooth HID connected state, Scanner disconnect current device and wait other device to pair.
PAGE 8
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.