User's Manual

2. Drill three holes using the tag mounting bracket as a template to mark holes.

3. Push rivets through tag mounting bracket and mounting surface.

4. Use hand-held rivet gun to secure tag to mounting surface.

It could take up to 3 squeezes of the gun to successfully secure a rivet and sheer off excess pin.

1. Make sure the 3.6V lithium battery is installed properly in the tag (see other side).

2 Slide tag into mounting bracket (labels right-side up) until it locks in place.

3To enable tab, ensure that the On Designation can be seen through the window on the mounting

bracket. If successful, the tag should beep twice after inserted into the bracket. When removed from

the bracket, the tag will beep once before shutting off.

4 To disable tag, ensure that the Off Designation can be seen through the window on the mounting bracket. If

successful, the tag should not beep after being inserted into the bracket.Replacing the Battery

Tools and Materials

• Replacement 3.6V lithium battery, size AA

1. Remove the battery cover: push firmly against the grooved thumb plate to release the catch

and slide the cover slowly down as shown.

When removing the battery cover, hold it as it comes loose to prevent dropping it.

2. Remove the discharged battery from its compartment.

The lithium battery can be harmful to the environment. Please follow current procedures for safely

disposing of lithium batteries.

Copyright protection claimed includes all forms and matters of copyrightable material and information, now allowed by statutory or judicial law

or hereinafter granted. Information in this guide is subject to change without notice and does not represent a commitment from the vendor.