User's Manual
&RQILJXULQJ6LJQSRVW2SHUDWLRQ6HWWLQJV
(FKR3RLQW6LJQSRVW,QVWDOODWLRQ*XLGH
&RQILJXULQJ6LJQSRVW2SHUDWLRQ
6HWWLQJV
Either before or after the Signpost is installed, the installer should set
and verify the following settings for operation. This activity is
performed using a computer having the Signpost Host software
application installed.
Before verifying these settings, you need to connect the computer to
the Signpost, which is documented in “Connecting Signposts to a
Computer” on page 3-2.
» To verify the operation settings:
The following Signpost Host application parameters need to be
verified.
1. Configure the Signpost ID (1 to 65535)
The Signpost ID should be a unique number in the facility. The
Signpost can be identified in the system by associating this
number with a description in the Site Server configuration.
2. Transmit group number (0 to 10)
The Transmit group number is used when a number of Signposts
are transmitting at the same time or a different time. The factory
setting is 0. The Signpost will not synchronize when the group
number is 0. When you program a number from 1 to 10, Signposts
having the same group number will transmit simultaneously.
Otherwise, they transmit at a different time.
3. Beacon Control on/off
The Beacon Control on/off option is used to program the tag
whenever changing the beacon mode of the tag is required. When
this option is disabled, the tag remains in the same mode. When
the option is enabled, the tag beacon mode will be changed
according to the command.