Quick Reference Guide
Table Of Contents
- Contents
- About the Savi SMR-650-216 Mobile Reader
- Hardware Components
- Savi SMR-650-216 and Intermec CK61G Mobile Computer
- Reader Communication
- Docking and Charging the Intermec CK61G
- 1. Connect the AC power cord to the power supply.
- 2. Connect the power supply to the dock charger and plug it into an AC power outlet.
- 3. Unzip the two zippers that connect the lower section of the soft case to the upper section.
- 4. Unsnap the snaps that connect the lower section of the soft case to the upper section.
- 5. When the lower section of the soft case is free, fold it up out of the way of the Savi Boot Adapter on the bottom of the Intermec CK61G. The Intermec CK61G ships with a plastic NI (Non-Incendive) protection cover on the boot adapter connector.
- 6. Before docking the Intermec CK61G Mobile Computer, use a screwdriver to remove the plastic NI cover and store it in the pouch.
- 7. Insert the Intermec CK61G into the dock charger by sliding the molded slots on either side of the boot adapter onto the corresponding guides on the dock charger.
- 8. Press down until you feel the adapter engage the dock charger.
- Optional Charging Method Without the Docking Station
- Resetting the SMR-650-216
- Using the Intermec CK61G Mobile Computer
- Optimizing the SMR-650 Reader Tag Collection Range
- Optimal CK61G Mobile Device Battery Life
- 1. Turn on the mobile device.
- 2. Tap Start > Settings.
- 3. Select the System tab.
- 4. Tap Backlight.
- • Check Turn off backlight if device is not used for and select 5 min.
- • Uncheck Dim backlight if device is not used for 15 seconds.
- • Check Turn on backlight when a button is pressed or the screen is tapped.
- • Under Brightness Level, move the pointer to the midway point or less.
- • Uncheck Turn off backlight if device is not used for.
- • Uncheck Dim backlight if device is not used for 15 seconds.
- • Check Turn on backlight when a button is pressed or the screen is tapped.
- • Under Brightness Level, move the pointer to the midway point or less.
- • Under On All Power, check Restore backlight state on resume.
- • Under Automatic Backlight Control, select Turn Off In Bright Light.
- • Under Battery Power > Device turns off after =, select 5 minutes.
- • Under Battery Power > Screen turns off after =, select 5 minutes.
- • Under External Power > Device turns off after =, select Disabled.
- • Under External Power > Screen turns off after =, select Disabled.
- Contacting Savi Support Services
- Specifications
5
About the Savi SMR-650-216
Mobile Reader
The Savi® SMR-650-216 Mobile Reader is a portable radio frequency
identification (RFID) reader that communicates with Savi RFID tags.
The Savi SMR-650-216 Mobile Reader attaches to the Savi Boot Adapter
and is factory-installed on the Intermec® CK61G Mobile Computer. The
adapter is installed at the factory and cannot be purchased separately. The
reader is positioned at an angle to the mobile device to improve tag read
performance.
W
ARNING: If you remove the Savi Boot Adapter and the Savi Mobile
Reader SMR-650-216 from the Intermec CK61G Mobile Computer, you
will void the Savi warranty.
Do not remove the Intermec CK61G Mobile Computer from the soft case
except for cleaning.
Hardware Components
The following components are included in the Savi Model
CK61-KIT-C-531.
• Savi SMR-650-216 (factory mounted on the Intermec CK61G Mobile
Computer)
• Intermec CK61G Mobile Computer (with 64 MB RAM, 128 MB of
nonvolatile storage, with an additional 256 MB SD card memory, two
batteries (lithium ION 2400 mAh, and two styluses)
• Savi Intermec CK61G Mobile Computer Boot Adapter (factory
mounted on the Intermec CK61G Mobile Computer).
• Savi soft case with shoulder strap (factory installed on the Intermec
CK61G Mobile Computer)
• Intermec CK61G dock charger with integrated battery charger