User Manual

7DJ3ODFHPHQW
6DYL7DJ67,QVWDOODWLRQ*XLGH 
7DJ3ODFHPHQW
Savi Technology recommends that you mount SaviTag ST-654 on a flat
surface, with the tag’s longitudinal axis aligned vertically. For optimal radio
communication, place SaviTag ST-654 as high as possible, safe from
impact (for example, between the ribs of an ISO-type shipping container),
and away from obstructions on the asset.
When SaviTag ST-654 is mounted in its optimal position:
◆ It is mounted at no less than a 6-foot (1.8 meters) elevation.
◆ The tag’s longitudinal axis is aligned vertically. See “Applying the Tag”
on page 23 for a mounting example.
The tag beeps twice if you install a fully charged battery. The tag beeps
three times if you install a battery with low charge; replace it with a
charged battery. When removing and replacing a charged battery, you
may need to wait a few seconds after replacing the battery to hear the
confirmation beep.
 Replace the battery cover
using a coin or screwdriver.
With the coin placed in the
battery cover groove, push the
cover in. Turn the battery
cover counterclockwise 1/4 to
1/2 of a turn to properly seat
the cover. Turn the battery
cover clockwise until it fits
flush with the tag case. Be
careful not to overtighten.
Make sure the battery cover is
completely closed and that it
is not cross-threaded.
 Dispose of the used battery according to local safety requirements.