Operating instructions

Memory Transmission
21
2
-
--
-Sending a Fax Message
Immediately
To send a fax message immediately,
use Immediate Transmission. If you
have just set up an original for broad-
casting, Immediate Transmission will
interrupt the current communication.
Your original will not be sent until
previously queued files have been
sent.
-
--
-Automatic Redial
If a fax message could not be trans-
mitted because the line was busy or
an error occurred during transmis-
sion, redialing is done 2 times at 10
minutes intervals (these figures vary
according to which country you are
in).
If redialing fails after two redials, the
machine cancels the transmission and
prints the Transmission Result Report
or Communication Failure Report.
-
--
-Broadcasting Sequence
If you dial several destinations for the
same message (Broadcasting) the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
Broadcasting. For example, if you
specify four destinations A through D
for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
-
--
- Checking the Transmission
Progress
To check which destinations the fax
message has been sent to so far, print
the TX file list.
-
--
- If Memory Runs Out While
Storing an Original
If you run out of memory while stor-
ing an original (free space reaches
0%),
“Memory full”
is displayed.
Press [Exit] to transmit the stored pag-
es only.
Note
❒ By default, successfully scanned
pages are sent. If you wish to
change this setting, please contact
your service representative.
Usfax-new18.tif