Operating instructions

Solving Problems
73
4
Solving Problems
This table lists some common problems and their solutions.
Problem Solution Refer to
Image background appears
dirty when received at the
other end.
Adjust the scan density. P.30
“Image Density (Con-
trast)”
Printed or sent image contains
spots.
The Document Feeder (AR-
DF) or exposure glass is dirty.
Clean them. See the Copy Ref-
erence manual.
Make sure that ink or eraser is
dry before setting the original.
---
Received image is too light. Request the sender to increase
the image density.
---
When using moist, rough or
processed paper, the printed
image may be partly invisible.
Only use recommended pa-
per.
See Appendix, “Acceptable
Types of Originals” in the Ad-
vanced Features manual.
When
D
appears on the dis-
play, toner is beginning to run
out. Replace the toner car-
tridge soon. See the Copy Ref-
erence manual.
---
Message appears blank at the
other end.
The original was set upside
down. Set it properly.
P.12
“Setting Originals”
You want to cancel a Memory
Transmission.
If the original is being stored,
press the
{Clear/Stop}
key.
P.23
“Canceling a Memory
Transmission”〈
BASIC FEA-
TURES
〉
“Canceling a Memo-
ry Transmission”
If the original is being sent,
use “Check/Cancel TX Files”
in the Information menu.
See Chapter4, “Checking and
Canceling Transmission
Files” in the Advanced Fea-
tures manual.
You want to cancel an Imme-
diate Transmission.
Press the
{Clear/Stop}
key. P.4
“Operation Panel”
You cannot add any destina-
tion in Group though it does
not reach the maximum
number.
99 destinations have been pro-
grammed with the number
keys (999 with the optional
Expansion Memory). Pro-
gram more numbers with
Quick Dials or Speed Dials.
See Chapter1, “Chain Dial”,
“Redial” or “Subaddress” in
the Advanced Features manu-
al.