Fax Machine Operating Instruction

Transmission Features
27
3
Transmission Features
Stamp
The optional Document Feeder is re-
quired.
When sending a fax message using
the Document Feeder (ADF), the ma-
chine can stamp a circle mark at the
bottom of the original. This stamp in-
dicates that the original has been suc-
cessfully stored in memory for
Memory Transmission, or that it has
been successfully sent for Immediate
Transmission.
Limitation
Stamp only works when scanning
from the Document Feeder.
You cannot turn the Stamp feature
on or off while a document is being
scanned.
Do not open the Document Feeder
while scanning the document.
Document jam could occur.
Note
When the stamp starts getting
lighter, replace the cartridge. See
P.91 “Replacing the Stamp Car-
tridge”.
If a page was not stamped even
though the Stamp feature is turned
on, you need to re-send that page.
By default, Stamp is turned off. If
you use this feature often, you can
adjust the User Parameters so that
the home setting is on. In this case,
Stamp can easily be turned off for
any single transmission by press-
ing the {F3} key. See P.72 “User Pa-
rameters” (Switch00, Bit0).
A
Press the {
{{
{F3}
}}
} key.
The Stamp indicator will light.
Pressing the {F3} key again will
turn it off.